5
Assembly
5.1
General
These assembly instructions enable the owner to install, re-install or replace the DC-Com unit himself. The owner
must appoint a coordinator who is authorised to issue instructions before assembly work commences.
Despite detailed information, errors cannot be excluded when the installation is assembled by the customer. For
this reason, we recommend that this work be carried out by our trained specialists or by persons authorised by
us.
The wiring of the Demag chain hoist complies in all respects with current DIN VDE and accident prevention regu‐
lations.
Unauthorised intervention and modifications eliminate compliance with these regulations.
DANGER
Live components
Danger to life and limb.
It must be possible to switch off the power supply by means of a device to disconnect the power supply (e.g.
mains connection or isolating switch with a padlock).
The chain hoists are supplied with power from an AC power network. The voltage and frequency of the AC pow‐
er network must match the data specified on the rating plate of the chain hoist.
5.2
Safety instructions for assembly
DANGER
Incorrect assembly
Danger to life and limb.
Incorrect installation may result in severe injury and/or damage to property. Therefore, this work may only be
carried out by authorised, instructed personnel who are familiar with the principle of operation of the machine in
compliance with all safety regulations.
–
Ensure sufficient working clearance before starting assembly work.
–
Secure and fence off the working and danger zone.
–
If an elevating work platform is used for assembly, only use appropriate attachments for the lifting of per‐
sons which ensure that work is carried out in a safe and stable position.
–
Only suitable, tested and calibrated tools and accessories may be used for assembly or disassembly work.
–
Wear protective equipment.
–
Be careful when working on open components that have sharp edges. Risk of injury.
–
Keep the working area clean and tidy. Store any unneeded machine or installation parts and tools in such a
way that there is no risk of them falling.
–
Fit components correctly and as intended. Comply with specified bolt tightening torques. Incorrectly fitted
components may fall and cause severe injuries.
–
Welding work may only be carried out by persons who are specially qualified. DIN welding work require‐
ments must be fulfilled. The electrode holder and earth must be connected to the same assembly when
welding work is carried out. Serious damage may otherwise be caused to the hoist.
–
Customer-specific regulations must be observed.
DANGER
Live components
Danger to life and limb.
Work on electric equipment may only be carried out by qualified specialist personnel (
nel", Page 10) in compliance with the safety regulations.
32
214
80
2 44/291
113
Содержание DC-Com 1
