DEMAG DC-Com 1, Руководство по эксплуатации

Страница: 55 / 116

7 Operation
7.1 Safety instructions for operation
WARNING
Incorrect operation
Risk of injury due to incorrect operation.
Incorrect operation may result in severe injury or damage to property. The equipment may only be operated by
authorised and instructed personnel in compliance with all accident-prevention and safety regulations. National
regulations for the use of cranes and lifting appliances must be observed and followed.
–
The owner must arrange for operating personnel to be trained.
WARNING
Crushing hazard
There is a risk of injury due to parts of the body being crushed/sheared or clothing or hair becoming entangled
when loads are lifted or lowered.
–
Do not touch the chain.
– Do not reach between the upper and lower chain entry point.
– Do not reach into the area of the Manulift coupling when the quick-release coupling is connected.
– Do not reach between the load hook opening and the load handling attachment when loads are lifted.
– There must be nobody present in the immediate danger zone when the load is set down.
WARNING
Risk of burns
There is a risk of burns from contact when the chain hoist is in operation.
Do not touch hot motor housings.
WARNING
Suspended load. Falling parts.
Danger to life and limb if lifted loads are dropped.
Keep out of the danger zone at all times
–
Keep a sufficient safety distance.
– Never step under a suspended load.
– Loads must not be lifted above persons.
– Wear protective equipment.
WARNING
Non-compliance with operating regulations/industrial safety regulations
Danger to life and limb if relevant regulations are disregarded.
Machinery may only be operated in compliance with relevant national operating regulations, e.g. BGV D6 for
cranes in Germany.
–
If required, apply a copy of the relevant operating regulations, part no. 214 748 44, at a suitable place
where operators can read them at any time (e.g. at the mains connection switch).
The machine must not be put into operation or must be taken out of service immediately if any defects or irregu‐
larities relating to operating safety and reliability or functions are detected.
Safety devices must not be rendered inoperative or modified contrary to their intended use.
214
80
2 44/291
113
55