Back to Contents Page
Memory
Dell™ 500 Service Manual
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide
.
You can increase your computer memory by installing memory modules on the system board. See "Specifications" in your
Owner's Manual
for information on the memory supported by your computer. Install only memory modules that are intended
for your computer.
NOTE:
Memory modules purchased from Dell are covered under your computer warranty.
Your computer has two user-accessible SODIMM sockets, DIMM A and DIMM B, accessed from the bottom of the computer.
NOTICE:
If you need to install memory modules in two connectors, install a memory module in the connector labeled
"DIMM A" before you install a module in the connector labeled "DIMM B."
Removing Memory Module(s)
The memory modules are located under the bottom cover on the computer.
1. Follow the procedures in
Before You Begin
.
2. Turn the computer over, loosen the eight captive screws on the bottom cover and remove it.
1
cover
2
captive screws (8)
NOTICE:
To prevent damage to the memory module connector, do not use tools to spread the memory module
Содержание Vostro 500
