Replacing a WLAN Card
1.
Insert the WLAN card connector into the system board connector at a 45- degree angle.
2.
Connect the antenna cables to the WLAN card that you are installing.
If the WLAN card has two triangles on the label (white and black), connect the white antenna cable to the connector labeled "main" (white triangle), and
connect the black antenna cable to the connector labeled "aux" (black triangle).
If the WLAN card has three triangles on the label (white, black, and gray), connect the white antenna cable to the white triangle, connect the black
antenna cable to the black triangle, and connect the gray antenna cable to the gray triangle.
3.
Replace the M2 x 3-mm screw that secures the WLAN card.
4.
Replace the hard drive (see
Replacing the Hard Drive
).
Back to Contents Page
1
WLAN card
2
system board connector
3
antenna cables (2)
NOTICE:
The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors on the card and on the system board,
and realign the card.
NOTICE:
To avoid damage to the WLAN card, never place cables under the card.
NOTE:
This procedure assumes that you have completed the removal procedure first.
Содержание Vostro 1310
Страница 24: ......
