Replacing the Display Assembly
1.
Align the display hinges with the holes in the base of the computer, then lower the display into place.
2.
Route the display cable and antenna cables beneath the plastic tabs on the palm rest.
3.
Slide the antenna cables through the hole in the palm rest and the base of the computer.
4.
Connect the display cable to the display cable connector on the system board.
5.
Replace the captive grounding screw.
6.
In sequential order, replace the four M2.5 x 5-mm screws in the base of the display assembly.
7.
Replace the keyboard (see
Replacing the Keyboard
).
8.
Replace the hinge cover (see
Replacing the Hinge Cover
).
9.
Close the display and turn the computer over.
10.
Replace the WLAN card (see
Replacing a WLAN Card
).
11.
Replace the hard drive (see
Replacing the Hard Drive
).
Display Bezel
Removing the Display Bezel
1.
Follow the instructions in
Before Working on Your Computer
.
1 display cable connector 2 captive grounding screw
3 antenna cables (3)
4 display assembly
CAUTION:
Before you begin the following procedure, follow the safety instructions that shipped with your computer.
NOTE:
This procedure assumes that you have completed the removal procedure first.
NOTICE:
Ensure that the display cable and antenna cables are properly routed and secured beneath the plastic tabs on the palm rest.
CAUTION:
Before you begin the following procedure, follow the safety instructions that shipped with your computer.
Содержание Vostro 1310
Страница 24: ......
