Dell PowerVault 725N, Установка стойки

Страница: 31 / 194

Ra c k I n s t a l l a t i o n G u i d e 1-25
F i g u r e 1 - 1 7 . R o t a t i n g t h e F r o n t M o u n t i n g B r a c k e t f o r F l u s h - M o u n t
I n s t a l l a t i o n
12
Install the stiffening bracket in the appropriate holes at the back of the slide
assemblies and secure the bracket with a 12-24 x 0.5-inch pan-head Phillips screw on
each slide assembly (see Figure 1-16).
If the vertical rack is 3 inches wide, use the holes at the back end of the slide
assemblies (shown in Figure 1-16). If the vertical rack is 6 inches wide, use the holes
located 3 inches in front of the holes at the back end of the slide assemblies.
13
Grasp the cable tray at each end and lower it into the holes on each slide assembly (see
Figure 1-16).
14
Press the front hook firmly into its socket until it clicks, securing it in place.
nuts (2 per bracket)
shoulder washers
(2 per bracket)
12-24 x 0.5 inch pan-head Phillips screws
(remove 2 per bracket)
NOTE:
These screws are shown reinstalled on
the other slide assembly.
12-24 x 0.5 inch pan-head Phillips
screws (install 2 per bracket)
mounting flange
JO525bk0.book Page 25 Monday, January 27, 2003 12:29 PM