l
Excessive humidity.
Action
1.
Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2.
."
3.
Lay the system on its right side.
4.
."
5.
Remove all expansion cards installed in the system. See "
" in "Installing System Options."
6.
Let the system dry thoroughly for at least 24 hours.
7.
Replace the cover. See "
8.
Stand the system upright.
9.
Install the bezel. See "
10.
Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
If the system does not start properly, see "
."
11.
If the system starts properly, shut down the system and reinstall all of the expansion cards that you removed. See "
"Installing System Options."
12.
Run the system board tests in the system diagnostics to confirm that the system is working properly. See "
."
Troubleshooting a Damaged System
Problem
l
System was dropped or damaged.
Action
1.
Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2.
."
3.
Lay the system on its right side.
4.
."
5.
Ensure that the following components are properly installed:
l
Expansion cards
l
Power supplies
l
Fans
l
Drive-carrier connections to the SCSI backplane board, if applicable
6.
Ensure that all cables are properly connected.
7.
Replace the cover. See "
8.
Stand the system upright.
9.
Install the bezel. See "
10.
Run the system board tests in the system diagnostics. See "
CAUTION:
See your
System Information Guide
for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.
CAUTION:
See your
System Information Guide
for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.
Содержание PowerEdge 700
Страница 22: ...zero insertion force Back to Contents Page ...
Страница 93: ...Back to Contents Page ...
