Dell PowerConnect J-SRX240, Руководство по оборудованию

Страница: 110 / 160

Table 35: Services Gateway Power LED Status (continued)
Possible Cause and Corrective Action Meaning LED Status
• Verify that the AC power cord from the power
source to the device is not damaged. If the
insulation is cracked or broken, immediately
replace the cord or cable.
• Ensure that the socket you plug in is in working
condition.
• Ensure the device has an AC input voltage
between 110 and 240 VAC.
• If you cannot determine the cause of the problem
or need additional assistance, contact Dell
Support. See “Dell Support” on page 96.
The device is not receiving power. Off
Related Topics Monitoring the J-SRX240 Services Gateway Chassis Using the CLI on page 87
•
•
Monitoring the J-SRX240 Services Gateway Components Using LEDs on page 89
•
Monitoring the J-SRX240 Services Gateway Using Chassis Alarm Conditions on page 92
•
Dell Support on page 96
Resetting the Configuration File When the J-SRX240 Services Gateway Is Inaccessible
You can use the J-SRX240 Services Gateway's Reset Config button to restore the device's
configuration file when the current one is faulty or fails. You can also change the default
behavior of the Reset Config button.
This topic includes the following sections:
• Using the Reset Config Button on the J-SRX240 Services Gateway on page 94
•
Changing the Reset Config Button Behavior on the J-SRX240 Services
Gateway on page 95
Using the Reset Config Button on the J-SRX240 Services Gateway
If a configuration fails or denies management access to the services gateway, you can
use the Reset Config button to restore the device to the factory default configuration or
a rescue configuration. For example, if someone inadvertently commits a configuration
that denies management access to a services gateway, you can delete the invalid
configuration and replace it with a rescue configuration by pressing the Reset Config
button.
NOTE: The Reset Config button is recessed to prevent it from being pressed accidentally.
The rescue configuration is a previously committed, valid configuration. You must have
previously set the rescue configuration through the J-Web interface or the CLI.
94
PowerConnect J-SRX240 Services Gateway Hardware Guide