Dell PowerConnect 6224, Руководство по интерфейсу командной строки

Страница: 1226 / 1372

1226
Sflow Commands
The default maximum header size is 128.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
console(config)#sflow 1 sampling ethernet 1/g2 1500 50
sflow sampling (Interface Mode)
Use the
sflow sampling
command in Interface Mode to enable a new sflow
sampler instance for this data source if rcvr_idx is valid. Use the "no" form of
this command to reset sampler parameters to the default.
Syntax
sflow
rcvr-index
sampling
sampling-rate
[
size
]
no sflow
rcvr-index
sampling
•
rcvr-index
— The sFlow Receiver for this sFlow sampler to which flow
samples are to be sent. If no receiver is configured, then no packets will be
sampled. Only active receivers can be set. If a receiver expires, then all
samplers associated with the receiver will also expire. (Range: 1 - 8).
•
sampling-rate
— The statistical sampling rate for packet sampling from
this source. A sampling rate of 1 counts all packets. A rate of 0 disables
sampling. A value of n means that out of n incoming packets, 1 packet will
be sampled. (Range: 1024 - 65536).
•
size
— The maximum number of bytes that should be copied from the
sampler packet (Range: 20 - 256 bytes).
Default Configuration
There are no samplers configured by default.
The default sampling rate is 0.
The default maximum header size is 128.