Dell PowerConnect 6224, Руководство по интерфейсу командной строки, Страница: 788 / 1372

788
IPv6 Routing Commands
• interface — Identifies direct static routes from point-to-point and
broadcast interfaces, and must be specified when using a link-local address
as the next hop.
• tunnel or vlan — Is the tunnel or vlan interface to associate with the route.
•
next-hop-address
— Is the IPv6 address of the next hop that can be used to
reach the specified network.
•
preference
— Is a value the router uses to compare this route with routes
from other route sources that have the same destination. (Range: 1-255)
Default Configuration
1 is the default value for
preference
.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configure an IPv6 static route.
console(config)#ipv6 route 2020:1::1/64 2030:1::2
ipv6 route distance
Use the ipv6 route distance command in Global Configuration mode to set
the default distance (preference) for static routes. Lower route preference
values are preferred when determining the best route. The
ipv6 route
and
ipv6 route default
commands allow optional setting of the distance of an
individual static route. The default distance is used when no distance is
specified in these commands. Changing the default distance does not update
the distance of existing static routes, even if they were assigned the original
default distance. The new default distance is applied to static routes created
after invoking the ipv6 route distance command.