Dell PowerConnect 6224, Руководство по интерфейсу командной строки, Страница: 209 / 1372

ACL Commands
209
Default Configuration
This command has no default configuration.
Command Mode
Mac-Access-List Configuration mode
User Guidelines
The no form of this command is not supported, as the rules within an ACL
cannot be deleted individually. Rather the entire ACL must be deleted and
respecified.
The assign-queue and redirect parameters are only valid for permit
commands.
Example
The following example configures a MAC ACL to deny traffic from MAC
address 0806.c200.0000.
console(config)#mac access-list extended DELL123
console(config-mac-access-list)#deny 0806.c200.0000
ffff.ffff.ffff any
ip access-group
no ip access-group
Use the
ip access-group
or
no ip access-group
command to apply/disable an
IP based egress ACL on an Ethernet interface or a group of interfaces. An IP
based ACL should have been created by the access-list <
name
> …
command with the same name specified in this command.
Syntax
ip access-group
name direction seqnum
•
name
— Access list name. (Range: Valid IP access-list name up to 31
characters in length)
•
direction
— Direction of the ACL. (Range: In or out. Default is
in
.)