Dell OptiPlex 330, Руководство по обслуживанию

Страница: 76 / 170

76
Disk Drives and Media
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m
3
Reinstall the hard-drive bracket in the chassis (see the following
figure).
Insert the bracket into the chassis by inserting the hooks in the slots on
the front of the chassis. Then lower the bracket to the bottom of the
chassis, making sure that the latch on the externally accessible drive
bay is engaged. Replace the screw holding the drive bracket to the
drive bay.
I n s t a l l i n g t h e H a r d - D r i v e B r a c k e t ( D e s k t o p C h a s s i s )
4
Connect the interface cable for the drive. See " Attaching Hard-Drive
Cables (Desktop Chassis) ."
NOTICE: To avoid possible damage, you must match the colored strip on the
interface cable with pin 1 on both the drive and system board connectors.
a
If you are installing an EIDE device, ensure that the IDE interface
cable is properly connected to the EIDE connector on the system
board.
screw
hooks (3)
hard-drive bracket
latch