Dell OptiPlex 330, Руководство по обслуживанию, Страница: 126 / 170

126
Hard-Drive Thermal Sensor
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m
Mini Tower Chassis
• Removing the hard-drive thermal sensor
• Replacing the hard-drive thermal sensor
Removing the Hard-Drive Thermal Sensor (Mini Tower Chassis)
CAUTION: Before you perform this procedure, see " Precautionary
Measures ."
NOTICE:
Before disconnecting a peripheral from the system or removing a
component from the system board, verify that the standby power indicator on
the system board has turned off. To locate this indicator, see "
System Board
Components " or " Interior Service Label ."
1
Turn off the computer and peripherals, disconnect them from their
electrical outlets, wait at least 5 seconds, and then remove the
computer cover .
2
Remove the front panel .
3
Remove the AGP card brace .
4
Remove all expansion cards .
5
Remove the expansion-card guide .
6
Remove the hard-drive bracket .
7
Disconnect the hard-drive thermal sensor cable from the control panel
connector (THERMAL). To locate this connector, see " Control Panel
Components ."
8
Feed the thermal sensor cable through the routing holes in the drive
door and the front wall of the chassis (see the following figure).
NOTE: You must open the drive door to feed the thermal sensor cable
through the cable routing holes. The sensor cable routes through an
enlarged hole in the front chassis wall and through a hole in the drive
door.
9
Remove the thermal sensor from the clip in the front wall of the
chassis.
The hard-drive thermal sensor is mounted on the chassis frame where
the hard-drive bracket is installed.