Figure 86. Installing the system board
4
Using the Phillips #2 screwdriver secure the system board to the chassis with screws.
Next steps
1
Install the Trusted Platform Module (TPM).
NOTE:
The TPM plug-in module is attached to the system board and cannot be removed. A replacement TPM plug-in
module is provided for all system board replacements, where a TPM plug-in module was installed.
2
Replace the following:
a
Memory modules
b
Processors and heat sink modules
c
Internal USB key
d
vFlash/IDSDM module
e
Integrated storage controller card
f
Expansion cards, if installed
g
Expansion card holder
h
GPU card holder
i
Air shroud
3
Reconnect all cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured by using the cable securing
bracket.
4
Follow the procedure listed in
After working inside your system
.
5
Ensure that you:
a
Use the Easy Restore feature to restore the Service Tag. For more information, see the Easy restore section.
b
If the Service Tag is not backed up in the backup flash device, enter the Service Tag manually. For more information, see the
Restoring the Service Tag by using the Easy Restore feature section.
c
Update the BIOS and iDRAC versions.
d
Re-enable the Trusted Platform Module (TPM). For more information, see the Replacing the Trusted Platform Module section.
6
Import your new or existing iDRAC Enterprise license. For more information, see the Integrated Dell Remote Access Controller User's
Guide at
Dell.com/idracmanuals
.
Installation and Service Manual
Installing and removing system components
137
