2. Follow the procedure listed in
Before working inside your system
3. If you are replacing the system board, remove all the components that are listed in the
section.
Steps
1. Unpack the new system board assembly.
CAUTION:
Do not lift the system board by holding a memory module, processor, or other components.
CAUTION:
Take care not to damage the system identification button while placing the system board into the
chassis.
2. Holding the system board by its edges, lower the system board into the chassis.
Figure 89. Installing the system board
3. Holding the Mezz card brackets by its edges, lower the brackets into the system board.
4. Using the Phillips #2 screwdriver, tighten the screws that secure the system board to the chassis.
5. Using the Phillips #2 screwdriver, tighten the screws that secure the Mezz card brackets to the system board.
Next steps
1. Replace the following components:
a.
NOTE:
The TPM Module must be replaced only while installing new system board.
b.
c.
d.
e.
f.
g.
h.
i.
Installing and removing system components
93
Содержание EMC PowerEdge MX750c
Страница 11: ...System information label Figure 5 Mechanical overview Dell EMC PowerEdge MX750c system overview 11 ...
Страница 12: ...Figure 6 Memory overview 12 Dell EMC PowerEdge MX750c system overview ...
Страница 13: ...Figure 7 System board Figure 8 Jumper settings Dell EMC PowerEdge MX750c system overview 13 ...
Страница 14: ...Figure 9 Quick Resource Locator Figure 10 System tasks 14 Dell EMC PowerEdge MX750c system overview ...