Dell EMC PowerEdge MX750c, Инструкция по установке и обслуживанию

Страница: 58 / 112

2. To release the memory module from the socket, simultaneously press the ejectors on both ends of the memory module
socket to fully open.
3. Lift the memory module away from the system.
Figure 48. Removing a memory module
Next steps
1. Replace the memory module .
2. If you are removing the memory module permanently, install a memory module blank. The procedure to install a memory
module blank is similar to that of the memory module.
NOTE: When operating your system with single processor, install processor DIMM blanks/brackets in processor 2 memory
sockets.
Installing a memory module
Prerequisites
1. Follow the safety guidelines listed in Safety instructions .
2. Follow the procedure listed in the Before working inside your system .
3. Remove the air shroud .
CAUTION: To ensure proper system cooling, memory module blanks must be installed in any memory socket that
is not occupied. Remove memory module blanks only if you intend to install memory modules in those sockets.
Steps
1. Locate the appropriate memory module socket.
CAUTION: Handle each memory module only by the card edges, ensuring not to touch the middle of the
memory module or metallic contacts.
2. If a memory module is installed in the socket, remove it.
NOTE: Ensure the socket ejector latches are fully open, before installing the memory module.
3. Align the edge connector of the memory module with the alignment key of the memory module socket, and insert the
memory module in the socket.
CAUTION: To prevent damage to the memory module or the memory module socket during installation, do
not bend or flex the memory module; insert both ends of the memory module simultaneously.
NOTE: The memory module socket has an alignment key that enables you to install the memory module in the socket in
only one orientation.
58 Installing and removing system components