Dell E70S, Инструкция по установке и обслуживанию

Страница: 108 / 238

Figure 106. Removing a heat sink
Next steps
If you are removing a faulty heat sink, replace the heat sink , if not, remove the processor .
Removing the processor
Prerequisites
WARNING: Remove the processor from processor and heat sink module (PHM) only if you are replacing the
processor or heat sink.
1. Follow the safety guidelines listed in the Safety instructions .
2. Follow the procedure listed in the Before working inside your system .
3. Remove the air shroud or remove the GPU air shroud .
4. Remove the processor heat sink module or remove the liquid cooling module .
CAUTION: You may find the CMOS battery loss or CMOS checksum error displayed during the first instance of
powering on the system after the processor or system board replacement which is expected. To fix this, simply
go to setup option to configure the system settings.
Steps
1. Place the heat sink with the processor side facing up.
2. Using your thumb, lift up the thermal interface material (TIM) break lever to release the processor from the TIM and
retaining clip.
3. Holding the processor by the edges, lift the processor away from the retaining clip.
108 Installing and removing system components