Dell 5230DN, Руководство по обслуживанию

Страница: 226 / 586

3-20
Service Manual
The page count can only be viewed and cannot be changed.
To view the page count:
1. Select Page Count from PRINTER SETUP.
2. Press Back to return to PRINTER SETUP.
Perm Page Count (permanent page count)
The permanent page count can only be viewed and cannot be changed.
To view the permanent page count:
1. Select Perm Page Count from PRINTER SETUP.
2. Press Back to return to PRINTER SETUP.
Serial Number
The serial number can only be viewed and cannot be changed.
To view the serial number:
1.
Select
Serial number
from PRINTER SETUP.
2.
Press
Back
to return to PRINTER SETUP.
Engine Setting 1 through 16
WARNING:
Do not change these settings unless requested to do so by your next level of support.
Model Name
The model name can only be viewed and cannot be changed.
Configuration ID
The two configuration IDs are used to communicate information about certain areas of the printer that cannot
be determined using hardware sensors. The configuration IDs are originally set at the factory when the printer
is manufactured, however the servicer may need to reset Configuration ID 1 or Configuration ID 2 whenever
you replace the system board. The IDs consist of eight hexadecimal characters, including 0 through 9 and A
through F.
Note:
When the printer detects a Configuration ID that is not defined or invalid, the following occurs:
•
The default standard model Configuration ID is used instead.
•
Configuration ID is the only function available in DIAGNOSTICS.
•
Unless the menu is in DIAGNOSTICS,
Check Config ID
displays.
To set the configuration ID:
1. Select Printer Setup from the Diagnostic mode.
2.
Select
Configuration ID
from the Printer Setup menu.
Submitting Selection
displays, followed by the value for Configuration ID 1.
3.
Enter the Configuration ID 1.
•
To select a digit or character to change, press or until the digit or character is underlined.