Figure 59. Installing a drive into the drive carrier
Drive backplane
The drive backplanes supported in NX3340 is 2.5 inch (x8) SAS and SATA.
NOTE:
Mixing of 2.5 inch 10K or 15K SAS drives with 2.5 inch 7.2K SATA on the same backplane is not supported. You can mix
solid state drives with hard drives on the same backplane.
Removing the drive backplane
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, remove the drives from the system before removing the backplane.
CAUTION:
Note the number of each drive and temporarily label them before you remove the drive so that you can replace them
in the same location.
NOTE:
The procedure to remove the backplane is similar for all backplane configurations.
1
Follow the safety guidelines listed in
2
Follow the procedures in
Before working inside your system
3
Remove the
.
4
Remove the backplane cover.
5
Remove all drives from the hard-drive slots from the front of the system.
6
Disconnect all the cables from the backplane.
Step
Press the blue release tabs and lift the backplane to disengage the backplane from the hooks on the system.
NOTE:
If your backplane has an expander board, then loosen the screws on the expander board before you remove the
backplane.
Installing and removing system components
99
