Figure 80. Installing the left control panel
5
Use the Phillips #1 screwdriver to install the screws that secure the cable cover to the system.
Figure 81. Installing the cable cover
Next steps
1
Install the
2
If applicable, install the
.
3
Follow the procedures in
After working inside your system
Removing the right control panel
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedures in
Before working inside your system
3
For ease of removal of the right control panel, remove the cooling fan #8 to access the cable latch.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cables properly
when you replace them to prevent the cables from being pinched or crimped.
Steps
1
Lift the cable latch, and disconnect the control panel cable from the connector on the system board.
2
Use the Phillips #1 screwdriver to remove the screws that secure the cable cover to the system.
Installing and removing system components
119
