Figure 30. Installing a memory module
Next steps
1
Install the air shroud.
2
If applicable, install the mid drive tray.
3
Follow the procedures in
After working inside your system
4
To verify if the memory module has been installed properly, press F2 and navigate to
System Setup Main Menu > System BIOS >
Memory Settings
. In the
Memory Settings
screen, the System Memory Size must reflect the updated capacity of the installed
memory.
5
If the value is incorrect, one or more of the memory modules may not be installed properly. Ensure that the memory module is firmly
seated in the memory module socket.
6
Run the system memory test in system diagnostics.
Processors and heat sinks
The processor controls memory, peripheral interfaces, and other components of the system. The system can have more than one
processor configurations.
The heat sink absorbs the heat generated by the processor, and helps the processor to maintain its optimal temperature level.
Removing the processor and heat sink module
Prerequisites
WARNING:
The heat sink may be hot to touch for some time after the system is powered down. Allow the heat sink to cool
before removing it.
1
Follow the safety guidelines listed in
2
Follow the procedures in
Before working inside your system
Steps
1
Use a Torx #T30 screwdriver, loosen the screws on the heat sink in the following order:
a Loosen the first screw three turns.
b Loosen the second screw completely.
74
Installing and removing system components
