Dell EMC PowerProtect DD9900, Руководство по установке

Страница: 55 / 96

Procedure
1. Remove the 6.8 mm adapters and replace them with the appropriate hardware from the kit:
a. Using a flat-bladed screwdriver, remove the two 6.8 mm adapters from the adapter
mounting block on the rails.
b. Select the correct adapters from the hardware kit and install the adapters into the
adapter mounting block.
2. Locate the 4U rack space designated for the shelf.
3. Install the right rail to the rear channel.
a. Align the right rail so that the alignment pins are centered on the middle holes of the
bottom two U spaces of the 4U space.
b. Move the bracket with the alignment pins to their correct location.
c. Push the rail back to secure the rail posts in the cabinet channel.
An audible click indicates that the rail is secure in the channel. Make sure the rear post/
catch mechanism is secure and attached.
4. Install the right rail to the front channel.
a. Align the front of the right rail so that it is level and the front rail pins are aligned with the
middle holes of the bottom two U spaces of the 4U space.
b. Pull the rail forward, with the posts aligned with the middle holes of the bottom two U
spaces of the 4U space.
An audible click indicates that the connection is secure.
5. Install the left rail by mirroring the previous steps.
6. Remove the shipping tape that is attached to the node rails.
Install the Disk Shelves in the Rack
Dell EMC PowerProtect DD9900 System Installation Guide 55