Dell EMC PowerProtect DD9900, Руководство по установке

Страница: 49 / 96

Figure 42 Installing the chassis bracket
CL5499
9. Place the chassis bracket over the center rail of the cable tray. Clip the free end of the
cable chains to the center flange on the chassis bracket.
Figure 43 Installing the bezel
10. Place the bezel over the front of the tray by pressing the release buttons on the bezel and
placing it over the retaining slots on the tray. Release the buttons and the tabs will mate
with the slots.
11. Refer to the application guide and connect the cables as required. Dress the cable runs with
proper cable strain reliefs when routing to the rack.
Disconnecting cables for a shelf installed with the 1U cable management tray
When servicing a shelf installed with the 1U cable management tray, cables might need to be
disconnected to perform servicing procedures.
Procedure
1. Unplug/disconnect all cables from the rear of the shelf to be serviced.
2. Disconnect the cable guide clips from the chassis.
Install the Disk Shelves in the Rack
Dell EMC PowerProtect DD9900 System Installation Guide 49