Del Medical EPEX Omniflex IV, Руководство по обслуживанию

Страница: 57 / 238

EPEX/Omniflex IV System Service Manual
Installing the System Hardware 3-9
Positioning the Equipment
After the equipment has been moved to the room and unpacked, position
the major components as shown on the site planning drawings. Ensure that
there is enough room between the components and the walls or other
equipment to complete the installation of components and cabling before
final placement.
Positioning the Generator
Locate the Material Safety Data Sheet and the Configuration List and make
copies. Originals are left on site. Send copies of these and the CDRH
Workbook to the Installation Coordinator.
Position the Generator according to the room layout drawing near the final
destination, leaving clearance for connections to the back panel. Refer to
Figure 3-3.
Key points to remember in moving the Generator cabinet:
If the door size is 2134 x 864 mm (84 x 34 in.) or more , the Generator
can be transported through the doorway while upright.
If the door size is less than 2134 x 864 mm (84 x 34 in.) , the Generator
must be tilted to the left to clear the doorway.
Figure 3-3.
Generator Cabinet
(Rear View)