DeDietrich Innovens MCA 15, Инструкция по установке и обслуживанию

Страница: 42 / 144

Y
Connect the heating pump (circuit
A
).
If underfloor heating is being used, put a safety
thermostat in place after the heating pump. The
safety thermostat will shut down the heating
pump in the event of overheating.
U
Connect the DHW tank anode.
CAUTION
4
If the tank is fitted with a Titan Active
System® impressed current anode,
connect the anode to the inlet (+ on the
anode, - on the tank).
4
If the tank is not fitted with an impressed
current anode, put the simulation
connector in place (delivered with the DHW
sensor - package AD212).
I
Connect the heating pump (circuit
B
).
O
Connect the 3-way valve (circuit
B
).
P
Connect the DHW sensor (Package AD212).
a
Connect the domestic hot water looping pump to the
M
AUX
outlet on the AD249 option.
z
Do not connect anything to the terminal block.
Settings to be made for this type of installation
Parameters
Access Settings to be made See chapter
INSTALLATION
"Installer" level
#SYSTEM
menu
EXTENDED
¼ "Displaying the parameters in extended mode", page
71
O.DHW:
(1) "Installer" level
#SYSTEM
menu
PUMP
¼ "Setting the parameters specific to the installation",
page 72
(1) The parameter is only displayed if
INSTALLATION
parameter is set to
EXTENDED
4. Installation MCA 15 - MCA 25 MCA 25/28 MI
40 29/04/2010 - 300022146-001-B