CBT36K Assembly Manual
Page
47
of 89
8.2.3.4.
Temporarily Move Resistors to Make
Soldering Easier:
It is easier to solder some of the leads if the
resistors are temporarily moved. Make sure you
position it back at the proper location prior to
soldering however.
8.3.
G
LUE
R
ESISTORS TO
B
ACKS OF
M
ID
-
B
ASS
D
RIVERS
:
Follow the next steps to attach the resistors to the
rear of the mid-bass drivers.
8.3.1.
Remove Tape from Rear of All Mid-
Bass Drivers:
Remove the electrical tape but be very cautious
not to allow any trash to fall into the ND91 magnet
hole.
FOR PROPER OPERATION OF THE
MID-BASS DRIVERS, THE MAGNET HOLES
MUST REMAIN OPEN.
8.3.2.
Apply Glue to Magnet:
Apply a small bead of hot glue to the magnet near
the terminals.
8.3.3.
Glue Resistors to Rear of Mid-Bass
Drivers:
Glue the mid-bass resistors to the magnets of the
ND-91 drivers and verify the resistor values:
1)
Driver 18 - 2.0 // 2.0
2)
Driver 16 - 3.0 // 3.0
3)
Driver 14 - 5.0 // 5.0
4)
Driver 11 - 1.5 // 1.5
8.3.4.
Lift Resistors and Squirt Glue
Underneath
Lift the resistors soldered to the Tweeter PCB
enough to squirt a small bead of glue underneath
them.
8.3.5.
Press Resistor Down Until Glue is
Set:
Press the resistor down and hold till the glue cools.
