CBT36K Assembly Manual
Page
23
of 89
5.4.2.
24 AWG Stranded-Wire Table:
Locate the stranded 24 AWG wire for the tweeter modules and cut to the lengths and quantities shown in
following table: (
Note
: Item 18 is below in the 24 AWG Solid-Wire Table).
Notes for the 24 AWG wire table:
For wire ends that need to be "Tinned", heat the wire with an 800 degree soldering iron and apply just
enough solder so the wire ends are evenly coated with solder.
5.4.3. 24 AWG Solid-Wire Table:
These wires are the wires cutoff from the resistors in the previous Section 5.3 “Configure and Trim the
Resistor Leads”.
