CBT36K Assembly Manual
Page
42
of 89
7.4.1. Bank 1 Tweeter Wiring Diagram:
1
2
3
4
5
6
16” Black
36” Red
4.5” Black
4.5” Red
4.5” Black
4.5” Red
4.5” Black
4.5” Red
22” Black
15” Red
U-Jumper
U-Jumper
To Speak-On Connector 15” Jumper
Red 2+, Black 2-
To Bank 2 Input
Bank 1 Wiring Diagram
Use 24AWG wire for all Tweeter Module wiring.
Fig. 14. Bank 1 wiring diagram for the tweeter-module shading network.
7.4.1.1. Close-up View of a U-Jumper Between Two Tweeter Modules:
All 20 U-Jumpers used to connect the tweeters were created from the resistor lead cutoffs. You will install
10 of these U-Jumpers on each front panel. Notice in the following diagram that the first two tweeter
modules do not have these series U-Jumpers but instead are connected with wire. Refer to the wiring
diagram for each of the banks and notice that some locations don’t use series U-jumpers but rather use
red and black stranded insulated wire as parallel jumpers. This is illustrated in the next photo.
7.4.1.2. Close Up of Insulated Wire Jumpers Between Tweeter Modules 1 and 2:
View of tweeter modules 1 and 2 with 4.5 inch insulated wire jumpers installed. Position the jumper wires so that
about 1/8” of bare lead is exposed for soldering.
7.4.2. Bank 2 Tweeter Wiring Diagram:
7
8
9
10
22” Black
15” Red
U-Jumper
U-Jumper
U-Jumper
Bank 2 Input
15” Black
to Bank 3-
27” Red
to Bank 5+
1.5//1.5 ohm
Bank 2 Wiring Diagram
Use 24AWG wire for all Tweeter Module wiring.
Resistor Lead is Soldered
to PCB
Fig. 15. Bank 2 wiring diagram for the tweeter-module shading network.
