CBT36K Assembly Manual
Page
13
of
89
8
2
3.1.2.12. Sound Absorption/Dampening Fiber:
Two One lb bags of Acousta-Stuf Polyfill absorption material.
9
3
3.1.2.13. Speaker Sealing Caulk:
One 36 inch roll of ¼ inch wide sealing caulk. This caulk is
used for wire management on the back of the front panels.
Strips are self-adhesive and stick easily to any surface it is
pressed against.
10
2
3.1.2.14. Four-wire Chassis-Mount Speaker Connector:
Neutrik Speakon NL4MP. Each cabinet has one of these
mounted on the bottom rear of the cabinet. The connector has
four wires which allow the both the mid-woofers and the
tweeters of the CBT36 to be connected with one connector.
A good reference for Speakon connectors and wiring is found
at:
http://www.n4tze.com/speakonconnectorwiring.pdf
.
11
2
3.1.2.15. Resistor, Non-Inductive Wire-Wound, 1.0 Ohm:
Mills brand, 12W, 1% Tolerance.
12
10
3.1.2.16. Resistor, Non-Inductive Wire-Wound, 1.5 Ohm:
Mills brand,12W, 1% Tolerance.
(
NOTE
: Image shows a 1.0 Ohm.)
13
4
3.1.2.17. Resistor, Non-Inductive Wire-Wound, 2.0 Ohm:
Mills brand,12W, 1% Tolerance.
(
NOTE:
Image shows a 1.0 Ohm.)
14
2
3.1.2.18. Resistor, Non-Inductive Wire-Wound, 2.5 Ohm:
Mills brand,12W, 1% Tolerance.
(NOTE:
Image shows a 1.0 Ohm.)
15
4
3.1.2.19. Resistor, Non-Inductive Wire-Wound, 3.0 Ohm:
Mills brand,12W, 1% Tolerance.
(
NOTE:
Image shows a 1.0 Ohm.)
16
4
3.1.2.20. Resistor, Non-Inductive Wire-Wound, 5.0 Ohm:
Mills brand,12W, 1% Tolerance.
(
NOTE:
Image shows a 1.0 Ohm.)
7
1
3.1.2.10. Front Panel Gasket Material:
One 36 ft roll of 1/2 inch wide x 1/16 inch thick Neoprene
Sponge. 18 ft of this gasket material will be used per speaker.
