Genesis MP
Chapter 3 – Connecting Additional Peripherals
◆
43
Adding PCI cards
You can add from three to six expansion cards in Genesis MP, depending on the model,
through the Peripheral Component Interconnect (PCI) bus. Cards are available to add
graphics, video, networking and other expanded capabilities to Genesis MP.
Genesis MP supports all PCI cards that work in Apple’s PCI equipped Power Macintosh.
PCI cards that only support IBM-compatibles are not compatible with your Genesis MP.
Here are the steps for installing a PCI card.
1. Open Genesis MP (loosen the side door panel) by following the easy instructions
listed previously in this chapter. Remember to turn everything off.
2. Put on your anti-static wrist strap.
3. Unscrew the screw and remove the metal PCI slot cover from the PCI slot you wish
to use to install your card.
Removing PCI Slot Covers
4. Align the PCI card over the motherboard connector and push down on the card
until it is firmly seated in the motherboard.
Installing PCI Card
Note: If you are installing a full length PCI card, be sure that the card aligns inside
of the card guide on the right edge of the card.
5 Reinstall the screw and replace the access port cover to secure the PCI card.
6. Reinstall Genesis MP’s side door panel by tightening down the four screws.
7. Install any software that came with the card.
