Genesis MP
Chapter 3 – Connecting Additional Peripherals
◆
47
If you are installing drives of both sizes, the table to the left shows the maximum
number of each size drive that may be installed into a Genesis MP.
Installing multiple hard drives
Adding SCSI devices into the Internal 3.5" bay
1. Open Genesis MP (loosen the side door panel) by following the easy instructions
listed previously in this chapter. Remember to turn everything off.
2. Put on your anti-static wrist strap.
3. Locate a pair of the small black SCSI rails and the four flat Phillips head screws
that came with Genesis MP.
3.5" Drive Rails & Screws
4. Install the rails onto each side of the 3.5" SCSI device so that the thumb end of the
rails are on the side of the SCSI device which has the power and SCSI connectors.
Installing Drive Rails
1" Tall
1.6" Tall
Drives
Drives
(1/3 height) (1/2 height)
7
0
5
1
3
2
1
3
1.6” high drives
1” high drives
SCSI power connector
SCSI connector
Thumb end of drive rail
