DAVIS TECHNOLOGIES TC-3 Series, Инструкция по эксплуатации

Страница: 16 / 60

15
TC3 Series Traction Control
www.moretraction.com
Installation
Installation of the system is very simple. It is very
important to make all connections correctly.
Improper installation could result in poor system
performance or damage to the system.
Keep all wires away from any spark plug wires and
coils or other sources of electrical noise and heat.
The unit should be mounted away from any sources
of electrical noise or high heat.
It is recommended to connect the power and ground
leads for the traction control directly to the ECU when
possible to reduce electrical noise issues.
Inputs such as ARM and Trans Brake Sync can be
triggered by either a positive or negative signal. This
can be configured using the Profiler PC Software.
Default input is POSITIVE trigger.
The RPM input needs to be a 5-12 volt square wave
typically found with a 3 wire Hall effect type sensor or
a standard tach signal.
See Appendix C