DAVIS TECHNOLOGIES TC-3 Series, Инструкция по эксплуатации

Страница: 39 / 60

38
TC3 Series Traction Control
www.moretraction.com
Start RPM sets the RPM of the measured shaft below
which the TC is not able to make a correction. This
allows some cars to “Get Up On The Tire” before
any corrections are allowed.
Start RPM
Save
+ +
- -
0 0
+ +
- -
0 0
+
-
0
Measured Shaft RPM
to Exceed Before
Traction Control Is
Active
Ramp In is the rate at which timing retard is restored
after a correction has ended. Ramp in is calibrated
in deg per sec. A value of 100 restore rate will take
1 sec to restore 100 degrees of retard, or 1/10
th of a
second to restore 10 degrees. This is a linear rate,
so the retard is “eased” back in so as not to upset
the tire again.
Ramp In
Save
+ +
- -
1 0
+
-
0
Speed At Which Retard
Is Ramped Back In After
Correction Ends.
(Degrees per Second.
100=10 deg in 1/10
th
Sec)
(Default = 100)