Datex-Ohmeda AS/3 Compact Monitor, Техническое справочное руководство

Страница: 72 / 92

Datex-Ohmeda AS/3 CM and CS/3 CMC
64
Document No. 896 623
Hemodynamic Modules
ECG measurement
34. Enter the ESTP : ECG service menu:
Monitor Setup
- Install/Service (password 16-4-34) -
Service (password 26-23-8) - Parameters - ESTP : ECG
Check that the ‘Timeouts’, ‘Bad checksums’ and ‘Bad c-s by mod’ values are not increasing
faster than by 50 per second. Check that the ECG/RESP board memories have passed the
internal memory test, i.e. ‘RAM’, ‘ROM’ and ‘EEPROM’ all state OK.
?
35. Check the module membrane key
ECG LEAD
(not available in NE12STPR/NESTPR type
modules).
Press the key at least for two seconds. Check that the selected ECG lead is changing on the
screen and the state for ‘Button’ in the service menu.
?
36. Check that the module mains power frequency ‘Power Freq’ value has been set according to
the supply frequency. If necessary change the setting by selecting
Power Freq .
?
For modules w/ respiration measurement
37. Check on the ESTP : ECG service menu that the ‘Resp Available’ and ‘RESP Measurement’
show ON
?
For modules w/ temperature measurement
38. Enter the ESTP : STP service menu:
MODULES - ESTP : STP
Check that the ‘Timeouts’, ‘Bad checksums’ and ‘Bad c-s by mod’ values are not increasing
faster than by 50 per second. Check that the STP board memories have passed the internal
memory test, i.e. ‘RAM’, ‘ROM’ and ‘EEPROM’ all show OK.
?
39. Check that the protection for temperature calibration is on, and the module configuration is
set correctly.
The ‘Protect key’ text in the menu should state OFF and the ‘Protect mode’ text should state
ON.