Datex-Ohmeda AS/3 Compact Monitor, Техническое справочное руководство

Страница: 20 / 92

Datex-Ohmeda AS/3 Compact Monitor, CS/3 Compact Monitor
12
Document No. 896 623
2.5 Software loading
The Software Cartridge attached to the B-CPU2/3 board contains the program for the CPU board
as well as for some other boards attached to the CPU bus. When the system is turned on, all
processors load their part of the software from the cartridge and after that start to execute their
program.
The CPU Board, B-CMCPU4 contains no external software cartridge. The softwares are always
loaded on the B-CMCPU4 boards already at the factory. For service procedures B-CMCPU4 boards
has a PC card drive, through which the software is loaded permanently on the board from the
software card.
UPI OR UPINET
Board
CPU
Board
Display
Controller
Board
Program
Memory Program
Memory Program
Memory
CPU BUS
Software
Cartridge
w/ B-CPU2/3 or w/ B-CMCPU4
Software
Card
Figure 5 Software loading
2.6 Parameter modules
The detailed structure of the parameter modules depends on the specific needs for each individual
parameter. Some common parts can be found inside the modules, however. The electronics inside
the module is usually divided into isolated (floating) and non-isolated sections. Typically the non-
isolated part consists only buffers needed to interface the module to module bus, the rest of the
electronics can be found from the isolated side. This includes the microcontroller together with
memory components, the front end analog electronics (amplifiers, etc.) and peripheral drivers to
control LEDs, sensors, valves and pumps.