44208-00006-000 DSV3-SP User’s Manual
Rev 0B
2/12/2009
32
Copyright © 2009 by Datastrip, Inc. All rights reserved.
Reproduction in whole or in part is prohibited.
12.1
Docking Station I/O
The docking station provides access to the wired I/O ports of the DSV3 mobile terminal. Shown below is
a photo of the bottom of the docking station depicting the location of each of the I/O connectors. Cables
are normally routed through the cable trough in the back of the docking station. There is a cable tie
anchor point that can be used to secure the cables.
12.2
Adjusting the Docking Station Backrest
The DSV3 docking station has an adjustable backrest. It is important
to adjust the backrest correctly to ensure proper operation. To use the
docking station with the DSV3-SP, ensure that the plastic backrest
support is in the forward position. This is done by removing the 2
Philips- head screws in the plastic backrest support, repositioning the
backrest support to the appropriate position, and then re-tighten the
screws.
•
Forward Position
: This position should be used for DSV3-SP
•
Rear Position
: This position should be used for DSV3-EP
13
Troubleshooting
P
ROBLEM
P
OSSIBLE REASON AND REMEDY
Unit does not power up
The battery may be not connected, or may be completely discharged.
¾
Open the battery access cover and verify that the battery is properly installed.
¾
Use the external AC power adapter to operate the unit and to
simultaneously charge the battery.
Please refer to Section 4.12.1 “Battery Charging and
Replacement”
Unit generates a single
“error” beep tone, and the
power LED flashes RED
once
¾
This is an indication that the internal battery is very low, and does not have
sufficient charge to run the unit at all.
¾
Plug in the AC power adapter to charge the battery AS SOON AS POSSIBLE
USB Host (x2)
Ethernet
USB Client
RS-232
12V Power
Input
Cable Tie
Anchor Point
Security Cable Loop
Cable Routing
Trough
Screws
Adjustment Plunger
Backrest
Support
