iBootBar
– Precision Version
Page 5
iBootBar_Precision_20160428e.doc
Firmware ver 1.41.32
Installation
Rack Mounting
The iBoot
Bar is designed for mounting in a standard 19” equipment cabinet.
1.
There are two L-shape brackets marked as
“L” and “R”, install the “L” bracket on the left side of the iBP chassis
then the
“R” bracket on its right side.
Installed L bracket:
Installed R bracket:
2.
Install the iBP to the standard 19-inch rack.
Ethernet
The iBootBar has a 10/100 Ethernet port. The default address is 192.168.0.254
Serial Port
The iBootBar has a 9 pin D subminiature connector for RS-232 serial control. The connector is configured as DCE
for direct connection to a laptop or other terminal device. Default serial parameters are 115,200 bps, 8 data, no
parity, 1 stop bit (115200,8,n,1).
Serial Port pinout:
Pin No
Description
1
Data Carrier Detect
2
Receive Data
3
Transmit Data
4
Data Terminal Ready
5
Signal Ground
6
Data Set Ready
7
Request to Send
8
Clear to Send
9
Ring Indicator
