Datamax I-Class, Руководство по обслуживанию

Страница: 31 / 88

Adjustments and Maintenance
2-21
2.4.5 Cleaning the Exterior Surfaces
When soiled, clean the outer surfaces of the printer with a general-purpose cleanser. (Never use
abrasive cleansers or solvents.)
1. Turn OFF and unplug the printer.
2. Using a soft cloth or sponge dampened with a general-purpose cleanser to wipe the exterior
surfaces clean.
3. Allow the surfaces to dry.
2.5 Application Version Updates
As available, application program (firmware) updates can
be found at http://www.datamax-oneil.com/ and then
installed.
The update can be performed in Ready Mode or in
Download Mode. Before starting, identify the current
Application Version by printing a Configuration Label.
Compare the Application Version string to those available
from our web site then download the desired file onto
your computer’s hard drive and proceed according to the
currently installed version:
•
If 2.091 or greater, see Section 2.5.1; or,
•
If 2.08 or less, see Section 2.5.2.
PARALLEL PORT A:
PORT DIRECTION:
UNI-DIRECTIONAL
PARALLEL PORT A:
NOT INSTALLED:
COMMUNICATIONS
SERIAL PORT A:
BAUD RATE:
9600 BPS
PROTOCOL:
BOTH
PARITY:
NONE
DATA BITS:
8
STOP BITS:
1
SERIAL PORT B:
NOT INSTALLED
SERIAL PORT C:
NOT INSTALLED
SERIAL PORT D:
NOT INSTALLED
USB PORT:
NOT INSTALLED
SYSTEM INFORMATION
PRINT BUFFER SIZE:
100 in.
FLASH SIZE:
2 MB
RAM TEST:
PASS
OPTIONAL LANGUAGES:
FRANCIAS.DLN
ITALIANO.DLN
DEUTSCH.DLN
ESPANOL.DLN
CONFI
CONFIGURATION
TUE 09:09 AM 29JUL2008
PRINTER KEY:
4308-TB10-020312-001
APPLICATION VERSION:
83-2284-11E4 11.054 07/07/2008
MCL Version: 1.20.02-126
BOOT LOADER:
83-2269-11A 11.01 10/02/2007
UNLOCKED:
*NONE
FPGA:
*
MACO:
NOT SET
MACR:
00-90-c9-01-d0-84

Note: If updating to version 11.021 or greater, the Boot Loader must be updated before
proceeding; see Section 2.6.
Also, those desiring an alternate menu language must also download the EFIGS menu
language file. Go to the EFIGS directory and copy 832296.01C (or most current version) to
lpt1: /b (where the DOS Copy command requires the /b parameter because this file
contains binary code).
WARNING
If an error occurs during the download the update will be terminated, and if the
process did not reach ERASING FLASH or UPDATING SOFTWARE, the previous program
will remain intact; otherwise, a successful download must be completed to make the
printer operable.