DATAMARS
R-IN 1300 MID User Manual – Rev
3.0
7 (40)
*id[_]
Delay (ms) between two inventories (for non continuous mode
only)
*id[0 .. 1000] (default 0 [ms], example *id530)
*rh[_]
Remove headers:
*rh0 does not remove the headers
*rh1 removes the headers (default)
*ec[_]
Echo:
*ec0 echo disabled (default)
*ec1 echo enabled
“echo” makes it possible to view the characters sent to the reader.
*sa[_]
Stand alone mode:
*sa0 stand alone mode disabled (default)
*sa1 stand alone mode enabled (detect)
When stand alone mode is enabled, the device will start reading
as soon as it is turned on.
*bu[_]
Buzzer Box (beeper).
*bu0: buzzer disabled
*bu1: buzzer activated on tags-detection
*bu2: buzzer activated on antenna-transmission
*nl[_]
New Line character(s) selection:
*nl0 line feed and carriage return (0x0D 0x0A) (default)
*nl1 line feed (0x0A)
*nl2 carriage return (0x0D)
*nl3 carriage return and line feed(0x0A 0x0D)
*pw[_]
Output power:
*pw[0 .. 4000] range of power from 0 to 4000 mW (default 2000
mW)
- Example *pw2000
The selected output power is an approximate value.
*dt[_]
Time between UIDs:
This parameter inserts a time delay between the transmission of
codes.
*dt[0..200] range of time between UIDs from 0 to 200 units
(default 0), 1 unit = 10 ms (example: *dt10 >> 100ms)
*lc[_]
Lock code:
*lc0 lock code disabled (default)
*lc1 lock code 1 enabled
*lc2 lock code 2 enabled
*lc3 lock code 3 enabled
Details for *lc1:
Any transponder is read just once.
To read a transponder again, another one must be read first.
The transponder is first detected only once without regard to the time spent in the field.
Details for *lc2:
A chip can be read again only if it was outside the reading area for more than *ti[_] seconds.
Details for *lc3:
A chip can be read again only if it was outside the reading area for more than *cn[_] chips.
*ti[_]
Time out:
*ti[0..180] time parameter for lock code 2 from 2 [s] to 180 [s]
(default 10 [s], example *ti10)
*cn[_]
Number of detections to loose a lock:
*cn[1 .. 9] counter parameter for lock code 3 from 1 [chip] to 9
[chips] (default 2 [chips], example *cn7)