DATAMARS
R-IN 1300 MID User Manual – Rev
3.0
20 (40)
At this point, after sending the read-command, the reader performs so many inventories as specified
waiting in between for the specified number of ms to expire. After having completed the inventories,
the system stops reading.
If the configured architecture is other than “Table-Top – non continuous”, those fields do not have any
influence on the behaviour of the reader.
4.11
M
ONITOR
The monitor tab is used for verifying whether the reader is active or not.
The “Start Reader” button makes the reader start its inventory cycles.
The “Stop Reader” button makes the reader suspend its reading process.
The “Start Monitoring” button permits to display the UIDs of the chips found by the reader.
The “Clear Result” button clears the UIDs display.
The “Stop Monitoring” button stops the display.
The led “D” (detection) is green if the reader sends UIDs, red otherwise
PLEASE NOTE:
UIDs are displayed only once: duplicated UIDs are not displayed again! This could give the
impression that the reader does not work correctly but this is NOT true. Please, in this case press the
“Clear Result” button. If you press the “Stop Reader” button, the reader stops its reading process.
Please click this button only if you are sure that the suspension of the reader activities does not cause
the loss of important data.
