Datalogic Magellan 8500Xt, Руководство по продукции

Страница: 58 / 480

2-28
Magellan
TM
8500Xt Scanner
Remote Display Cabling
Your installation should also take into account the routing of Remote Dis-
play cabling. Ensure that distance and obstacles spanned by the routed
cable will not kink, pinch or stretch it. Also keep in mind you may need to
drill a hole through which to route it.
NOTE
The Remote Scale Display connector end may be secured with a rubber band
during shipping to prevent damage to the “locking tabs”. After routing the
cable, remove this rubber band before connecting. Failure to remove the band
will keep the connector from latching properly.
Model 8300RD: Placing and Installing the Remote Display
Reference
Figure 2-17
while performing these procedures.
1. Determine where you want to install the Remote Scale Display
based on your counter design, the viewing angle, lighting consider-
ations and cable routing discussed previously. Reference
Figure 2-16
for the display’s physical dimensions. Optimally, the display(s)
should be approximately eye level to the viewer(s).
2. Use the appropriate template provided in
Figure 2-1 8
for 8300RD
model to mark locations of the mounting screw and cable routing
holes.
• For the 8300RD model, the mounting screw holes are on 3-1/2”
(85.1 mm) centers. The cable can either be routed through a
3 /4”
(19 mm) diameter hole directly under the mounting base or
through the cutout in the back of the base (see
Figure 2-17
).
3. Drill the mounting screw holes using a drill bit of the appropriate
diameter for your mounting screws or bolts.
4. Drill the cable routing hole using a 3 /4” (19 mm) drill bit (optional).