Datalogic Magellan 8500Xt, Руководство по продукции, Страница: 129 / 480

Product Reference Guide
6-11
2. After verifying the accuracy of each quadrant of the weighing sur-
face, remove all weight from the scale. This completes the Shift
Test.
Increasing- Load Test (Phase 3)
After completing the Shift Test, you must complete the Increasing Load
Test using 20.0, 25.0 and 30.0 pounds of weight.
NOTE
The upper limit of the scale is configurable according to the POS inter-
face type and may not necessarily be set at 30 pounds, which is the
standard setting. For this test, continue to place weights in five pound
increments only up to the upper weight limit set for your scale.
1. With the scale starting at zero, place 20.0 pounds in the center of
the weighing surface and check that the display reads between
19.99 and 20.01 lb.
2. Place an additional five pounds (25 pounds total) in the center of
the weighing surface. Check that the display reads between 24.99
and 25.01 lb.
3. Place an additional five pounds in the center of the weighing sur-
face increasing the load to 30.0 pounds and check that the display
reads between 29.99 and 30.01 lb.
Remove the weights and verify that the display reads 0.00.
Blanking Test
This test ensures that the scanner/scale will indicate its weighing capability
has been exceeded if a weight greater than 0.05 pounds over its maximum
upper weight is placed upon the unit.
1. Place weights that total the upper weight limit plus 0.051 pounds
on the scale. For example: If the upper limit is set at 30 pounds,
place weights totaling 30.051 pounds on the scale.