Datalogic AccuLazr AL5010, Руководство по линейке продуктов, Страница: 104 / 240

96 Operations AccuLazr™ AL5010 Product Line Manual
NETWORK LED during Normal Operations
Mode Description
Single TCP/IP Solid GREEN – AL5010 connected to a host.
NOTE: If both Host 1 and Host 2 are used, the LED will be
solid GREEN if either port is connected.
Off – No host connection.
NOTE: If UDP messaging is used (unconnected messages)
the Network LED will be off.
EtherNet/IP Solid GREEN – AL5010 made a connection to the PLC
Flashing GREEN – No connection made with the network
Flashing RED – Lost network connection
Controller/Client Controller
Solid
GREEN
– The correct number of client(s) with the
same group number have been found.
Flashing RED – All the client(s) with the same group
number have NOT been found
Client
Solid GREEN – Connected to a controller with the same
group number.
Off – Not connected to a controller with the same group
number.
NOTE: The mode indicated by the Network LED is dependent on the AL5010
configuration you are using. Ethernet/IP is the highest priority, Single TCP/IP mode
operation is the lowest.
Using Control Panel Buttons to Check Normal Operations
Ref Button Description
Restore to Scan
Head
Restores parameters from Mounting base to Scan
Head

Button must be pressed twice to initiate action.

See page 99 for procedure.
Backup to
Mounting Base
Downloads parameters from Scan Head to Mounting
base

Button must be pressed twice to initiate action.

See page 99 for procedure.
Test /Diagnostic
(Laser Shutoff)

Enables the AL5010 test mode.
(Test mode can also be selected remotely using
Tools > Commands > Test Mode .)

Use to perform laser shutoff. (See page 107.)
REMEMBER: AL5010’s control panel buttons can be enabled / disabled
through the use of the browser-based setup application.
(See Modify > AL5010 Configuration, Enable AL5010 Control Panel
Buttons.)
Accu-Sort Systems, Inc. 06-AL5010_Operations_R20.doc