96-30051-001 Rev. D3
DDN SFA12K (SFA OS 2.3.1) Hardware Installation & Configuration Guide | 45
The rackmount kit includes two sets of rails and screws.
shows one of the rack
rails.
Procedure:
1.
The two flanges should already be attached to the controller. If not, attach the flanges
to the two sides of the controllers using six screws
CAUTION !
The main purpose of the chassis handles is for rackmount use only.
Do NOT lift, carry, or transport the controller by the handles.
2.
Pull the inner rail out of the outer rail until it is fully extended
. Then press
the locking tab down to release the inner rail. Repeat for the other set of rails.
Figure 49. Controller Rack Rail
Figure 50. Flange on Controller
Use 3 Screws to Attach
One Flange
Chassis Handle