System Installation and Configuration
96-30051-001 Rev. D3
DDN SFA12K (SFA OS 2.3.1) Hardware Installation & Configuration Guide | 13
5.3
Procedure
NOTE :
Refer to the respective StorageScaler 8460 and StorageScaler 7000 User
Guides if you need detailed instructions for disk module installation.
To install a disk module:
1.
Slide the enclosure out from the rack by squeezing the tabs on both rack slides. Keep
pulling until the enclosure locks and you hear a clicking sound.
2.
Open the enclosure covers.
3.
Release the handle on the disk module.
4.
Insert the module into a disk bay. Cam the disk module home. The camming foot on the
base of the module will engage into the slot in the enclosure.
5.
When the module is fully inserted, close the handle.
6.
After you have installed all the disk modules (and blank modules) in this enclosure,
close the enclosure covers and engage all cover latches.
7.
Squeeze the tabs on both rack slides and push the enclosure back into the rack.
Figure 4. Shipping Screws on SS7000 Front Panel