DataApex Clarity INT7, Руководство пользователя

Страница: 14 / 42

INT7 A/D Converter 3 Installation
3.4.1 Measuring on Multiple Instruments
When measuring on multiple instruments using only a single INT7 to
gather data, rather than dragging the entire INT7 icon from the Setup
Control Modules list
①
, drag the individual detector signals ( FID , UV-VIS
in this case) to separate Instruments
②
. See Fig 6 on pg 10 . The
Instrument to which the particular signal is connected is listed to the right
③
of the detector name in the Setup Control Modules section.
Fig 6: System Configuration – multiple instruments
Note: Each independent Clarity Instrument must have separate Ext. Start Dig.
Input and Ready Dig. Output pins configured according to the actual
wiring.
Note: A larger number of Instruments can be set than the amount you have
purchased. You will not be able to measure on the surplus Instruments
(indicated by a blue symbol of the curve on the tab), but you may use them
e.g. for “offline” preparation of methods.
3.4.2 Using multiple INT7 converters
When using multiple INT7 s A/D cards, it will be necessary to add the INT7
card again, repeating the entire procedure described in the chapter
"Clarity Configuration" on pg 8 . from Step 3.
- 10 -