confirm. You will
hear a long beep and a voice prompt “setting finished”.
Operating method: [
AA
]
[
BB
]
[CC]
[
#
]
AA
indicates: 45 means 1st home appliance open address, 47 means 2nd home appliance open address,
BB indicates: the hour of the setting time
CC indicates: the minute of the setting time
For example: turn on the 2
nd
home appliance at 3:35a.m.
Operating method: [47]
[03]
[35]
[
#
]
SMS Command: 8888450335#
5 Timely Close Appliance
In setup status, use keypad to input [46,48 ],then input the hour [BB] and minute [CC] of the time and finally input [#] to
confirm. You will hear a long beep and a voice prompt “setting finished”.
Operating method: [
AA
]
[
BB
]
[CC]
[
#
]
AA
indicates: 46 means 1st home appliance open address, 48 means 2nd home appliance open address,
BB indicates: the hour of the setting time
CC indicates: the minute of the setting time
For example: turn off the 2
nd
home appliance at 23:35p.m.
Operating method: [48]
[23]
[35]
[
#
]
SMS Command: 8888482335#
8 Operation Instruction
Arm while outside
It means to guard all around your house while all are out; all the sensors of alerters are always working; when
the sensor is triggered by door, fire, gas leak, etc., the alarm system will sound the alarm. After you have done
these operations, the indicator of [Arm] on the main unit is always on.
Remote Control Operations: press [ ] on the remote control.
SMS Command: 12341#
Arm at Home
It means, for the safety, while somebody is at home, you need to enable the peripheral door, window, balcony
and perimeter sensors of the alarm system for fear of triggering the indoor sensors, which may cause improper
warning; then, you shall select Arm at Home, let just part of the sensors work and disable the other parts. Only if
you have set arm at home, can it work normally and at that time the [Arm ] indicator on the main unit is Slow
flickering.
Remote Control Operations: press [
] on the remote control.
Disarm
It means to stop the alarm when the main unit sounds the alarm or make the alarm system in the status of
non-warning. After disarm the guard, even if you trigger the sensor, the main unit would not sound alarm (excluding
24-hour defence zone and emergency button on the remote control) and the [Arm] indicator goes out.
Remote control operations: press [
] on the remote control.
SMS Command: 12342#
Cancel Alarm
10
