Code Pairing by Remote Control
Code Pairing of Remote Control
In the status of disarm, enter settings and press [Set
] once again, the main unit emits a short “trigger remote
controller” and all the indicators of the defence zone are always on, which indicate that the unit enters remote
control code pairing status; take a remote control required for code pairing and press any key on it to emit a
wireless signal to main unit; after the main unit receive the signal
“coding finished” a beep and all the indicators of
defence zone go out, which indicate the remote control succeeds in code pairing.
Cautions: the main unit can provide code pairing for at most 8 remote controls. Code pairing for all remote
controls is the same.
Delete Remote Control
In the status of disarm, enter settings and press [Set] once again, the main unit emits a long
“trigger remote
controller” and all the indicators of the defence zone are always on, and then it enters remote control code pairing
status; press and hold [Set
] for 3 seconds, the main unit emits a long “delete finished” and all the indicators of the
defence zone go out. Remote control paired successfully.
Cautions: when deleting remote control, all the remote controls would be deleted.
Code Pairing of defence zone
Code Pairing of defence zone
In the status of disarm, enter settings, press [Set] once again to enter the remote control code pairing status;
press [Set] once again and the indicator of defence zone 1 goes on; Prompt:
“trigger detector”then, take a sensor
required for code pairing and trigger an alarm to emit a wireless signal to the main unit; after the main unit receives
this signal, it emits a long “coding finished” and the indicator of defence zone 1 goes out, which indicate code
pairing in defence zone 1 is paired successfully.
Cautions: in the status of disarm, enter settings, skip code pairing of remote control and continue to press [Set],
and then the indicators of the defence zone go on one by one; select a defence zone to perform code pairing and
the indicator of this defence zone goes on. Repeat the code pairing operation in the paragraph above for all other
defence zone.
Code pairing for the defence zone on main unit can be overwrote automatically, which means only the last code
pairing is valid. Therefore, code pairing can only be performed for one sensor in a defence zone; in case the
number of sensors required is more than that of the defence zone, you can edit the address code and digital code
of the sensors of same type to be the same exactly. By doing so, you just need to perform code pairing for one
sensor, and then other sensors with the same codes can work normally. In alarm, it will indicate the same defence
zone.
Delete Code Pairing
In the status of disarm, enter settings and skip code pairing of the remote control; press [Set] once again, then
the indicator for defence zone 1 goes on; Prompt:
“trigger detector”,then, long press [Set], three seconds later the
5