System Test
Although the alarm system is used everyday, periodical maintenance and test are required to assure that it can
run stably, reliably and safely. Usually thorough test must
be performed on the alarm main unit every three months. You’d better check the sensor once a month; if not
permitted by conditions, you shall check it at least every three months.
Main Unit Test:
1. Check if it can enable/disable guard normally.
2. Check if it can normally dial the number for alarm.
3. Check if it can receive the signal from sensors normally or if the backup battery is normal.
Sensor Test:
1. Trigger a sensor manually to check if it can sound alarm normally.
2. Check the batteries of all the sensors to check if they are under voltage.
3. Check the emission of wireless sensors to see if it can communicate with the main unit normally.
Trouble Shooting
If any trouble, perform trouble shooting shown as below:
Always buzzing: Is the SIM card fit properly? Install again
Is the PIN code of SIM card set? Cancel it.
Power indicator always flickering: Is the network signal strong enough? Change place
The signal of Unicom card is weaker than that of China Mobile.
Alarm failure: Is the code normal or is code pairing finished successfully? Confirm the right code and perform code
pairing again
Is the sensor under-voltage and is its transmitting distance not long enough? Replace battery
Dialing failure: Is the signal of China Mobile strong enough? Change place
Is there enough balance on the GSM card for call? Recharge it
Siren failure: Are the positive and negative poles of siren right or in fine contact? Check
Are the defence zone set to mute alarm? Reset
Voice disorder: have you made recording? Record again
Failure in setting by remote control: do you enter the correct setting password (factory default: 8888)?
Remote control failure: do you enter the correct remote control password (factory default: 1234)
Cautions
For any consult or maintenance service, please contact our professional engineers or service providers.
Please do not disassemble, repair and alter the products without permission, or it may cause accidents and
faults.
13
