Arm indicator
Always on
Arm status
Slow flickering
Settings status/At home status
Fast flickering
Alarming status
Lights
3 seconds shiny look
Home network successfully, and normal standby
Flicker
Are registered or not installed SIM card network
Extinguish
System failure
Power-on for the First Time
Following the method of installation, install the SIM card of main unit, make wired connection and fit the
GSM antenna properly in order. Then plug the power adapter.
At this point, the host of the eight lights flashing cycle, after the host began to detect GSM network, the power
light flashes until the network is normal, the power light flashes slowly (3 seconds flashes once), the host is
disarmed ... ...
At last, slide the switch of backup battery to [ON] with nippers or a small screwdriver.
Factory Reset
First switch off the backup battery and cut off the power supply, press and hold the button [Set] on the top
of unit,then turn on the power adapter;
Z1
Light; 3 seconds after the buzzer "beep" a long sound, lights were
flashing, and finally release the button. Host settings have all been removed, restoring the value of a
successful factory.
Voice Record
In the status of disarm, press [Set] for 3
times, the main unit emits a long “beep”, and [Arm] indicator
flickers (once a second), then recording starts: recording at 30cm away from the main unit, with standard of
moderate voice; 10 seconds later, recording stops automatically and [Arm] indicator goes out.
Enter Setting
In the status of disarm, press and hold [Set]; 3 seconds later, the
main unit emits a long “beep”, [Arm]
indicator flickers and the main unit enters the setting status.
In the status of settings, as long as keeping the status of setting ([Arm] indicator flickers), you can program
different settings repeatedly. During setting, however, if you stop setting operation for over 30 seconds, the
main unit will exit from setting mode automatically and return to the status of disarm.
Exit Setting
After setting is finished, all the indicators of the defence zones is off but only [Arm] indicator flickers; press
[Set] for 3 seconds,the main unit exits from setting. [Arm] indicator goes off, the main unit returns to the status
of disarm.
3
4
